JKS - Winkie Drill



Download Brochure
 
Two men carry a Winkie Drill.  Helicopter the unit into remote drill sites.
Vary Drilling Speed, a 2 speed transmission, maximizes drilling speed.
Unipress frame enables steady feed pressure with minimum exertion.
Minimize change time & operator fatigue with a Winkie Tripod & Winch 
Aluminum Drill Rods are light and easier to transport and to hoist.
Specifications:
Gasoline 2 cycle air cooled 10hp engine (@ 400rpm).
Oil bath gear shift transmission.
Unipress hand feed, centrifugal clutch.
Maximum bit speed 1200 to 2800 rpm.
Weight : Drill 85lbs  Feed 100lbs.



7832003 Reduction Gear Unti
For Auger or Casing Dilling

Download Tech Data Sheet
Capacity:
Core Barrel  E-core Thin kerf IEWS
Core Diameter 0.995" (25.2 mm)
Hole Diameter 1 1/2" (38mm)
Depth: 425 to 475 ft (130 to 145 m)
Core Barrel: A-core Thin kerf IAWS
Core Diameter 1.385" (35.1 mm)
Hole Diameter 1.89" (48mm)
Depth: 350 to 400 ft (105 to 120 m)

                                                       Drilling capacities shown using aluminum drill rods.

Pricing:  Reconditioned Winkie Diamond Drill c/w 2 speed gear shift transmission, 10HP
                 air cooled engine, mechanical pull down approximately $15,000

USUALLY ONE RECONDITIONED UNIT AVAILABLE

PHQ are looking for used Winkie Drills to recondition

Home      Diamond Drill Page    Recon Page   Request Quotation   PHOTOS of Typical Unit   Download 45 Page Manual

Send mail to webmaster@partshq.com with questions or comments about this web site.

Last modified: August 16, 2009

Copyright © 1997 Parts HeadQuarters Inc. All rights reserved. Information in this document is subject to change without notice.  Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.