Parts HeadQuarters Inc





Technical Regulations of the Customs Union TR CU 010/2011 "On the safety of machines and equipment"
Come into effect from 15 February 2013!Пример сертификата

Technical regulations of the Customs Union TR CU 010/2011 "On the safety of machinery and equipment" was adopted by Decision of the Commission of the Customs Union on October 18, 2011 № 823.

"List of standards as a result of which, on a voluntary basis, compliance with the technical regulations of the Customs Union "On the safety of machinery and equipment" was approved by Decision of the Commission of the Customs Union on October 18, 2011 № 823.

This technical regulation was developed in accordance with the Agreement on common principles and rules of technical regulation in the RepuUnion.blic of Belarus, the Republic of Kazakhstan and the Russian Federation on November 18, 2010.

This technical regulation applies to machines and (or) equipment manufactured in circulation at the common customs territory of the Customs 

This technical regulation applies to machines and (or) equipment which were revealed and identified hazards with requirements to eliminate or reduce of them are installed in accordance with application № 1 and № 2 of the Technical Regulations.

 

    PHQ220 Jacklegs Stopers and Sinkers
    PHQ250 Jacklegs Stopers and Sinkers
    PHQ36IR Drill Feed Remote Centralizer
    PHQBBC120 Drill Feed Remote Centralizer
    PHQ1000 Drill Sled
    PHQ2000 Long Tom Jumbo
    PHQ3000 Drill Carrier
    JKS PackSack Drill and 4M Feed
    JKS Winkie Drill and Feed
    JKS Bazooka Diamond Drill
    JKS VEG Diamond Drill
    JKS VAG Diamond Drill